Aqua Lung - Professional Diving Equipment


					English


	Safety Information		Installing SureLock Weight Pouches
	Dealer Inspection and Service		Inflation Methods using the i3 System
	Warranty Information		Deflation Methods using the i3 System
	Basic Setup		Special Features
	Donning and Adjustment Procedures		Predive Inspection (i3 Inflation System)
	Weight Integration Features		Postdive Care and Maintenance

Attaching the MP Hose to the First Stage

1. Remove the inflator hose from the power inflator body by gripping the grooved sleeve over the quick disconnect coupling with your thumb and forefinger. Slide the sleeve back.

2. Remove the port plug from an MP port on the regulator using an appropriately sized wrench.

WARNING: DO NOT connect the inflator hose to a high pressure (HP) port (greater than 200 psi / 14 bar). This may cause the hose to burst when pressurized, which can result in serious injury. If you are unsure which regulator port is medium pressure (MP) or high pressure (HP), consult your regulator owner’s manual or your dealer before attaching the hose.

3. Check to ensure the o-ring is present and in good condition. Screw the threaded end of the hose into the port and tighten to 40 in/lbs (46 kg/cm) with a 9/16" wrench.